Logicube Omniclone Xi - Manual (Page 15)

GETTING STARTED
Logicube Omniclone Xi ™ User’s Manual 9
Power and Reset buttons
The Logicube Omniclone Xi™ includes one On/Off
switch and one reset button. The power switch is a
rocker switch that is located on the unit’s power
supply. The reset button is located on the back of the
unit underneath the Compact Flash Drive slot.
When the unit needs to be soft-booted (or power
cycled), press the reset button and hold it in
momentarily. Wait a couple of seconds and let go,
the unit will reboot and be ready to use in a few
seconds.
NOTE: User settings are retained after the unit is
restarted.
The user interface
The user interface (UI) has been designed with the
professional in mind. It is fast, responsive, and to the
point; which means it requires very few key strokes to
achieve a desired action.
NOTE: Please refer to Figure 6 as you read the
information below.
Touch Screen
The Omniclone Xi™ features an LCD Touch Screen
that allows the user to quickly input commands. This
screen replaces many of the buttons that were
present on older Logicube duplication products. The
screen is bright and easy to read. It also emits an
audible beep every time the touch screen is pressed.
This lets the user know that the touch screen is active.
Calibrating the Touch Screen
There may be times when the user wants to
recalibrate the Touch Screen. The procedure for this
is very simple as outlined in the procedure below:
1. Press the Reset button on the back of the unit
and hold it in.