Logicube Omniclone Xi - Manual (Page 22)

CLONING MODES AND SETTINGS
16 Logicube Omniclone Xi ™ User’s Manual
4. On the right hand side you will see a
designator for the partition type. Some
examples are:
•
16 - FAT16 partition
•
32 - FAT32 partition
•
NT - NTFS partition
•
Linux – Linux partition
•
?? - unknown partition
5. Touch the scroll icons to place the cursor by
a given partition, and then touch the space to
the left of the Volume Label multiple times to
cycle among the 4 options. See Figure 7
below.
6. Scroll to other partitions and repeat Step 5.
Note that it is OK to assign unique cloning
modes to each selected partition.
7. When finished, press the “Set” button. The
Selective Clone™ settings screen will
appear.
8. Adjust the “Verify”, “CHS” and “SPEED”
settings as needed. (These settings are
discussed later in this chapter).
9. You may now double-click the “Start/Stop”
button to start cloning.
NOTE: When multiple copies are required, all
you need to do is change the TARGET drives,
and hit “Start/Stop” twice. Your last selections
are used. If the unit senses that the MASTER
drive was changed (by reading the serial
number of the MASTER), it will again return you
to the selection screen, where you specify the
method of copy for each partition.
NOTE: If you wish to change the last used
settings (and the MASTER drive did not
change), follow the “Selective Clone Step-by-
Step” instructions above.
Figure 3: Selective Copy Modes
CleverCopy Use the CleverCopy
algorithm for this partition
Defragment Defragment this partition
on-the-fly (FAT16/32 only)