Logicube Omniclone Xi - Manual (Page 42)

THE DATABASE/BARCODE OPTION
36 Logicube Omniclone Xi ™ User’s Manual
11. When the cloning Session is finished, the unit
will write data to the database.csv file. If one
or more “Scan” lines are in the Config List,
then the User will be prompted to use the
Barcode Scanner.
Fig 3. Barcode Scan Prompt
12. When prompted, aim the Barcode Scanner at
the Barcode to be read. Hold the scanner at
an angle about 6 – 8 inches from the
barcode. Hold down the trigger until the
Scanner beeps.
13. After the data is collected, the unit will stop
with a “clone successful” message.
14. At this point the database.csv file can be
copied from the CF drive and imported into
the database program of your choice. Use
USB Mode to gain access to your CF drive.
Database Settings Menu
The Logicube DataBase™ Menu is made up of six
different settings:
Select Config – This setting allows the user to
choose a Config List from the Config.txt file. A
checkmark appears next to the selected list.
On the Config.txt file itself, the active list is denoted
by an asterisk ( * ) located next to the list title.
Database Off/On – This setting tells the
Omniclone-Xi to run the Database function during
the next cloning session. It will continue to do so
until the setting is turned off.
Printer Menu – This setting prints the collected
data through a printer that is connected to the
parallel port of the Omniclone-Xi™. When opened,
this setting will prompt the user to enter the number
of entries to be printed. For example, if 20 clones
have been performed with the database turned on,
the user can select any number of entries up to 20.