Logicube Omniclone Xi - Manual (Page 32)

CLONING MODES AND SETTINGS
26 Logicube Omniclone Xi ™ User’s Manual
4. Exit the General Preferences screen by touching
the Back icon. This will take you back to the
previous Settings screen.
Database
This setting is covered in Chapter 6: The
Database/Barcode Option.
Password
This setting is used to set a password that
restricts access to the Omniclone Xi™ unit. If a
password is set, then every time that the unit is
rebooted a password prompt will come up. As
long as the user enters the correct password the
unit will boot to the Main Splash Screen.
Setting a Password Step-by-Step
1. From anywhere in the menu system, press the
Set button to enter the Settings menu.
2. Touch the “General Preferences” icon located
in the lower left hand corner of the screen.
3. Touch the Password icon. If a password is not
already set then an alphanumeric keypad will
come up.
4. Enter a password that is nine characters or less.
Do not use spaces or unusual characters.
5. Touch the OK key when done, the unit will
reboot itself to the Password Entry Prompt.
6. Type in the password to access the Main Splash
Screen.
Removing a Password
A password can only be removed by reloading the
software on the Omniclone Xi™ unit. Please refer
to Chapter 10: Software Loading Instructions for
more details.