Logicube Omniclone Xi - Manual (Page 16)

GETTING STARTED
10 Logicube Omniclone Xi ™ User’s Manual
2. Press and hold the Set button, then release the
Reset button.
3. Hold the Set button until the unit boots to a
screen that reads “Touchpad Calibration.
Please touch square with finger (1/5)”.
4. Look for a square at the top of the screen.
Touch the square when it is located.
5. Repeat the previous step four more times. The
unit will count each time the square is pressed
correctly. It will count (1/5), (2/5), etc.
6. Once the screen has been calibrated, it will
reboot to the Main Menu Screen.
Buttons
The Omniclone Xi™ features two “Shortcut” buttons
that are located to the right of the touch Screen.
These buttons are available at all times.
•
START/STOP Button – Press it twice to begin a
cloning operation using the current settings; press
the START/STOP button in mid process to abort it.
A single key stroke presents a preview screen
where you can see the current setting, and decide
whether to press it again to begin the capture, or
back out to reconfigure.
•
SET Button – Press this button once to bring you
to the settings screen where you can change
capture modes and other settings of the unit.
Indicator Lights
The Omniclone Xi™ has indicator lights that are
located on the User Interface panel as well as on the
light bar. The lights are as follows:
The POWER indicator light is a red LED located to the
right of the Touch Screen. It remains on while the
Logicube Omniclone Xi™ is receiving power.
The STATUS indicator lights are located to the left of
the Touch Screen as a series of green LED’s. Each
Master and Target drive position has a corresponding
Status indicator. These lights are lit during cloning
operations and any operation that accesses the
Master or Target drive. They will flash as data is
transferred from one drive to the other.
The GREEN light on the light bar is also a general
Status indicator light. It will blink during a cloning or
diagnostic operation. In addition, if the unit completes
an operation successfully the green light will stay lit.