Logicube Omniclone Xi - Manual (Page 50)

USING THE USB PORT
44 Logicube Omniclone Xi ™ User’s Manual
Connecting the CF Drive to Windows via USB
This is necessary to load new software files to the
CF Drive. The CF drive is connected through
Windows via the Software Setup Screen.
Connecting Through the Software Setup Menu
USB connectivity is available for the CF drive
through the Software Setup Screen. This screen
resides in the unit’s Firmware and is not affected by
the software.
1. Make sure your PC is running in Windows 98 or
above.
2. Connect the USB cable (provided) to a PC USB
slot on one end. Do not attach the other end to
the Logicube Omniclone Xi™ yet.
3. Boot The Logicube Omniclone Xi™ while
holding down the Start/Stop button. The unit
will boot to the Software Setup Menu.
4. Use the Select button to Scroll down to “Engage
CF to USB”. Press the Start/Stop button.
5. A prompt will appear saying that the unit is in
USB Mode.
6. Attach the USB cable to the Logicube
Omniclone Xi™. You should now see some
activity on your PC screen, which depends on
the operating system.
7. If running ME/2000/XP your drive will
automatically be mounted and a drive letter will
be assigned to it.
8. If running 98/98SE you will be prompted to
install drivers. At the “have disk…” prompt
please point the PC to the drivers floppy
(provided), and the installation should complete
smoothly.
9. The CF Drive is now visible on Windows as an
external drive. You can copy software update
files, or anything else to/from the drive.
Removing USB devices
Before physically disconnecting the USB cloning
adapter and/or shutting down power to the