Logicube Omniclone Xi - Manual (Page 31)

CLONING MODES AND SETTINGS
Logicube Omniclone Xi ™ User’s Manual 25
the license key, follow this procedure to enter it into
your Logicube Omniclone Xi ™.
Set Option Step-by-Step
1. From anywhere in the menu system, press the
Set button to enter the Settings menu.
2. Touch the “General Preferences” icon located
in the lower left hand corner of the screen.
3. Touch the Set Option icon, a numeric keypad
will come up. Type in the 7-digit code that you
received from Logicube. Press OK when
finished.
4. If the code is typed in correctly, a message
reading “Option Enabled” will appear. The unit
will then reboot itself.
5. If the code is entered incorrectly, the display will
go back to the General Preferences screen.
6. If you cannot enter the code, exit the General
Preferences screen by touching the Back icon.
This will take you back to the previous Settings
screen.
Last Drive
This setting allows the user to determine the
maximum number of Target drives that can be
cloned on the Omniclone Xi™ unit at one time. For
example, an OCXi that normally clones 10 Target
drives can be set to clone 5 drives. The first 5
Target positions would be active while the
remaining Target positions would be turned off.
This reduces the cloning time slightly because the
unit knows not to access drive positions that are not
used.
Last Drive Step-by-Step
1. From anywhere in the menu system, press the
Set button to enter the Settings menu.
2. Touch the “General Preferences” icon located
in the lower left hand corner of the screen.
3. Touch the Last Drives icon, a numeric keypad
will come up. Type in the maximum number of
drives that you wish to clone. The number can
range from 1 to 10. Press OK when finished.