Logicube Omniclone Xi - Manual (Page 30)

CLONING MODES AND SETTINGS
24 Logicube Omniclone Xi ™ User’s Manual
if an error such as a bad drive sector is
encountered.
Skip - Skip will allow the Logicube Omniclone
Xi™ to continue by stepping over the bad
sector.
Retry - Retry option will instruct the Logicube
Omniclone Xi™ to make several attempts to
read data from the damaged area of the drive.
Recover - Recover will attempt to recover as
many bytes of data as possible from each bad
sector that is encountered
NOTE: data in any skipped sectors will NOT be
copied to the Target drive.
NOTE: The Omnidiagnostics™ option must be
installed before the On Error settings can be
accessed.
On Error Step-by-Step
1. From anywhere in the menu system, press the
Set button to enter the Settings menu.
2. Touch the “General Preferences” icon located
in the lower left hand corner of the screen.
3. Touch the On Error icon repeatedly to toggle
between the different On Error setting options:
Skip, Abort, Retry and Recover.
4. After the On Error setting is chosen, exit the
General Preferences screen by touching the
Back icon. This will take you back to the
previous Settings screen.
NOTE: The Omniclone Xi™ checks the Master
drive for bad or weak sectors during any cloning
operation. It will not check the Target drives
unless the Verify setting is set to 1% or 100%.
Set Option
All optional software packages are already inside
your Logicube Omniclone Xi™ (and are
automatically updated when you install a newer
software version). To use an option like NTFS
Clevercopy, Selective Clone, Master Manager or
Omnidiagnostics™, it first needs to be enabled.
To enable OmniDiagnostics™ on your Omniclone
Xi ™, contact Logicube to purchase a license key
that is unique to your unit. Once you have obtained