Logicube Omniclone Xi - Manual (Page 21)

CLONING MODES AND SETTINGS
Logicube Omniclone Xi ™ User’s Manual 15
unique copy method
3
to use for each. The available
methods are:
Clever Clone™ – The default mode that lets the
Omniclone Xi™ determine the best (usually fastest)
way to clone. It is denoted by the light bulb icon. It
works with all FAT16/FAT32 and NTFS type
partitions.
NOTE: NTFS Clever Copy™ is an optional feature
and will only be available if purchased and installed
on your unit.
Defragment – Forces the defragmentation of all
partition data. This mode uses an advanced
defragmentation algorithm to create a Target
partition with no gaps and with contiguous files. It
works with FAT16/FAT32. Defragmentation is a
rather slow process and should be used only when
a single copy is required of a given Master drive. In
cases where multiple copies are desired, it is much
better to use a defragmentation program on the PC
for the Master and then move the Master drive onto
the Omniclone Xi™.
NOTE: Clever Copy™ mode will resort to the
defragmentation method if the given partition is
FAT16 and a cluster size change is required to
create a valid Target partition.
Partition Mirror – Simply streams over the full
contents of the selected partition without allowing
any partition scaling (Do not confuse this mode with
the Mirror copy mode which mirrors the entire
Master drive). This method is available for any
partition type. This is the only method available to
unrecognized partitions.
Selective Partitions™ Step-by-Step
1. From anywhere in the menu system click the
“Set” button to enter the Settings menu.
2. Press the Cloning Mode icon that appears in
the upper left-hand corner. A list of the
available cloning modes appears.
3. Press the “Selective” icon, the unit will
immediately power the Master drive and
display the partition table.
3
Note that not all modes are available for all partition types.