Logicube Omniclone Xi - Manual (Page 57)

SOFTWARE LOADING INSTRUCTIONS
Logicube Omniclone Xi ™ User’s Manual 51
Note: Windows 2000 and NT that have NTFS file
systems cannot be used since NTFS is not
accessible through DOS. The file systems that are
compatible include FAT16 and FAT32. One
possible workaround for this is to configure the boot
diskette to create a RAMDRIVE and then copy and
run the update files from that drive.
Logicube Omniclone Xi™ Software Update
Note: Make sure the update is running on the PC
and the Logicube Omniclone Xi™ is connected to
the host PC via the supplied parallel cable.
1. Remove the Master Drive from the unit if it is
connected.
2. Boot The Logicube Omniclone Xi™ while
holding down the Start/Stop button. The unit
will boot to the Software Setup Menu.
3. Use the Select button to Scroll down to “Load
SW to P.Port”. Press the Start/Stop button.
4. Follow any LCD on-screen prompts. The PC
should indicate that the software update is
loading. The update will run for one to three
minutes after which the Logicube Omniclone
Xi™ will restart.
5. Check the version and date of this software by
pressing the “About” icon at the main menu
screen.