Logicube Omniclone Xi - Manual (Page 14)

GETTING STARTED
8 Logicube Omniclone Xi ™ User’s Manual
unit. In 2 – 3 seconds, the main “Splash”
screen appears.
Connecting Serial ATA (SATA) Drives
1. Locate the Master position on the top of your
Omniclone-Xi™ unit. You will notice three
connections: One for a flat cable (the drive data
cable) and another for a small drive power
cable. Above is the third connector for the
Serial ATA cable.
Note: The drive that is cloned from is always
referred to as the Master drive and the drives that
are cloned to are always referred to as the Target
drives.
2. Attach the 5” SATA cable to the SATA and
drive power connectors.
3. Connect the Master hard drive to the cable.
Note: SATA drives usually do not need to have a
jumper set to Single Master.
4. Follow steps 1 – 3 to attach drives to the Target
positions of the Logicube Omniclone Xi™.
5. Connect the AC Power Cord to the back of the
Logicube Omniclone Xi™ and power-up the
unit. In 2 – 3 seconds, the main “Splash”
screen appears.
Connecting other types of drives
Logicube sells specialized adapters that allow the
following types of drives to be connected to the
Logicube Omniclone Xi™:
•
2.5” Laptop drives (also called Notebook drives).
•
1.8” Laptop drives, (e.g. Toshiba iPod™ drives).
•
Compact Flash (CF) Drives.
Other specialized adapters are also available. If you
are unsure about the type of drive that you have,
please contact Logicube Technical Support for
assistance.
Note: SCSI drives and older IDE drives that are
smaller than 500MB (unless LBA-enabled) are not
supported by the Logicube Omniclone Xi™.