Lanier AP3200 - Manual (Page 55)

41
4. Troubleshooting
Error & Status Messages on the Operation
Panel
Messages Description Comments
Add Staples The stapler is empty. Replace the staple refill with a
new one.
⇒ P.71 “Adding Sta-
ples”
Add Toner The printer is out of toner. Install a new toner bottle. ⇒
P.75 “Replacing the Toner Bot-
tle”
Call Service
Power Off On There is a malfunction in the
printer. Turn the printer power off and
on. If the message appears
again, contact your sales or
service representative.
Call Service
SC_XXX
The Service Code Number
identifies the failure. Turn the printer power off and
on. If the message appears
again, contact your sales or
service representative.
Close Bridge
Unit Cover
The cover of Bridge Unit Type
320 is open. Close the cover of Bridge Unit
Type 320.
Close
Finisher Cover
The cover of the finisher is
open. Close the cover of the finisher.
Close
Front Cover The front cover is open. Close the front cover of the
printer.
Close
Mailbox Cover
The cover of CS370 (mailbox)
is open. Close the cover of CS370
(mailbox) cover.
Close Right
Cover
The right cover of the printer
is open. Close the right cover of the
printer.
Close R-Cover at
Paper Tray Lower right cover 1 or 2 is
open. Close lower right cover 1 or 2.
Close Upper
Right Cover
The upper right cover is open. Close the upper right cover.
Cls. Interchange
Unit Cover
The interchange unit cover is
open. Close the interchange unit
cover.
Energy Saver 1 In Energy Saver 1 mode. Press an operation panel key
or send a job from the comput-
er to wake the printer up.