Lanier AP3200 - Manual (Page 62)

Troubleshooting
48
4
Getting Printer Information over the Network
Printer current status
You can check the printer's current status using telnet.
❖ ❖ ❖ ❖ UNIX
Use the lpq command or stat parameter of rsh, rcp, or ftp.
❖ ❖ ❖ ❖ telnet
Use status command.
Reference
For more information, see “Remote Maintenance by telnet” in the Operat-
ing Instructions for the Network Interface Board included as a PDF file on
the CD-ROM.
Messages Description Comments
Add Staples The stapler is empty. Replace the staple refill with a
new one.
⇒ P.71 “Adding Sta-
ples”
Add Toner The printer is out of toner. Install a new toner bottle. ⇒
P.75 “Replacing the Toner Bot-
tle”
Call Service Power Off On There is a malfunction in the
printer. Turn the printer power off and
on. If the message appears
again, contact your sales or
service representative.
Call Service SC_XXX The Service Code Number
identifies the failure. Turn the printer power off and
on. If the message appears
again, contact your sales or
service representative.
Close Bridge Unit Cover The cover of Bridge Unit Type
320 is open. Close the cover of Bridge Unit
Type 320.
Close Finisher Cover The cover of the finisher is
open. Close the cover of the finisher.
Close Front Cover The front cover is open. Close the front cover of the
printer.
Close Mailbox Cover The cover of CS370 (mailbox)
is open. Close the cover of CS370
(mailbox) cover.
Close Right Cover The right cover of the printer
is open. Close the right cover of the
printer.
Close R-Cover at Paper Tray Lower right cover 1 or 2 is
open. Close lower right cover 1 or 2.
Close Upper Right Cover The upper right cover is open. Close the upper right cover.