Lanier AP3200 - Manual (Page 66)

Troubleshooting
52
4
Remove Paper from Staple
Tray There is paper in the stack unit
of the finisher. Remove paper from the stack
unit of the finisher.
Important
❒ Remove the paper from the
output tray before it be-
comes full. If you leave pa-
per in the output tray, it
can cause a paper misfeed.
Remove Paper Mailbox Tray
# The CS370 (mailbox) tray # is
full.
# : Tray Number
Remove paper from the CS370
(mailbox) tray.
Important
❒ Remove the paper from
output tray before it be-
comes full. If you leave pa-
per in the output tray, it
can cause a paper misfeed.
Remove Paper Shift Tray The shift tray of the finisher is
full. Remove paper from the finish-
er tray.
Important
❒ Remove the paper from the
output tray before it be-
comes full. If you leave pa-
per in the output tray, it
can cause a paper misfeed.
Remove Paper Standard Tray The standard output tray is
full.
Remove paper from the out-
put tray.
Important
❒ Remove the paper from
output tray before it be-
comes full. If you leave pa-
per in the output tray, it
can cause a paper misfeed.
Replace Maintenance Kit It is time to replace parts in-
cluded in Maintenance Kit
Type 270. Replace Maintenance Kit Type
270. For more information
about how to replace the kit,
see the “Maintenance Kit Type
270 Replacement Guide” that
comes with the kit. After re-
placing the kit, clean the regis-
tration rollers.
⇒ P.84
“Cleaning the Registration Roll-
er”
Replace PCU It is time to replace Photo Con-
ductor Unit Type 320. Replace Photo Conductor Unit
Type 320.
⇒ P.77 “Replacing
the Photoconductor Unit”
Messages Description Comments