Lanier AP3200 - Manual (Page 67)

Error & Status Messages on the Operation Panel
53
4
Reset Duplex Unit Correctly AD380 (duplex unit) is not set
correctly. Set AD380 (duplex unit) cor-
rectly.
Reset Fusing Unit Correctly There is no fusing unit, or the
fusing unit is not installed
properly. Install the fusing unit proper-
ly. For more information
about the fusing unit, see the
"Maintenance Kit Type 270
Replacement Guide" that
comes with the kit.
Reset PCU Correctly There is no Photo Conductor
Unit Type 320, or Photo Con-
ductor Unit Type 320 is not in-
stalled properly. Install Photo Conductor Unit
Type 320 again. For more in-
formation about Photo Con-
ductor Unit Type 320, see the
"Photo Conductor Unit Type
320 Replacement Guide" that
comes with the photoconduc-
tor unit.
Resetting Job... Resetting print job. Wait for while.
Reset Tray# Correctly There is no paper tray, or the
indicated tray is not set cor-
rectly.
# : Tray Number
Note
❒ This message appears only
for the default tray. ⇒ P.99
“Job Control Parameters”
Set the tray correctly.
Waiting... Printer is waiting for the next
data to print. Wait for a while.
Warming Up... The printer is now preparing
for printing. Wait until the printer is
warmed up.
Messages Description Comments