Paradyne 392xPLUS - Manual (Page 108)

DCP Operation
3-71 3920-A2-GN31-30 November 1996
Entering Telephone Numbers and Dial Command Modifiers into Directory Locations
The following example uses an empty directory location for describing how to enter a telephone
number. If you want to change an existing telephone number in any of the 24 directory locations,
follow the same procedures.
To add a telephone number to a directory location, make the following selections:
F1
02: z
Nxt
" #
F2 F3
Select Nxt until a blank directory appears on the LCD. (The cursor ( _ ) always appears in the first
character position.)
Select F2 (
" ) or F3 ( # ) until the desired character is selected. This can be an alpha or numeric
character.
F1
02:
z
Nxt
" #
F2 F3
Press the key to move the cursor to the next character position.
Continue this key sequence until the dial command modifiers and telephone number are entered.
(Refer to Table 3-9 for a list of valid dial command modifiers.)
F1
01:9W5556789
z
Nxt " #
F2 F3
To save the number just entered, scroll to the next directory location by selecting Nxt. The number
is now stored in nonvolatile memory.
Table 3-9 describes what can be entered in directory locations.