Paradyne 392xPLUS - Manual (Page 113)

COMSPHERE 392xPlus Modems
3-76 November 1996 3920-A2-GN31-30
Remote Branch
The Remote branch of the Top-Level menu allows you to control the remote modem’s DCP using
the local modem’s DCP. This function allows you to change configuration options and control test
functions in a remote modem. Any changes made to configuration options while using the Remote
branch are not saved until you exit the Remote branch. This function is only available when using
either V.34, V.33, V.32 terbo, V.32bis, V.32, TMp, or V.29 modulation schemes.
Remote
“Status”
Status Configure Plist Control Test SubHS Call_Setup Tlk/Data Security
Choose Address
(TMp Control only)
Choose Password
(TMp only)
(Not in
TMp Trib)
Secondary Prim (data blckd)
(ExitRem appears
instead of Remote when
using Remote Mode)
The following conditions must be met before using the Remote branch:
•
A connection using either leased lines or the dial network must be established.
•
The Access from the Remote configuration option must be enabled in the remote modem.
•
In point-to-point networks, the Remote Access Password configuration option must be the
same for both the local and remote modems. In multipoint networks the remote access
password must be entered at the appropriate prompt.
•
For multipoint control modems, the network management address of the tributary modem
must be entered at the appropriate prompt.