Paradyne 392xPLUS - Manual (Page 70)

DCP Operation
3-33 3920-A2-GN31-30 November 1996
To implement Change, select the appropriate function (Active, Delete, or Skip). (For Skip, you will
need to press the
key until Skip appears.)
F1
Poll List:yyyyyy
Ent
"
xxx
F2 F3
The function field (yyyyyy) displays the function selected (Active, Delete, or Skip).
The address field (xxx) displays the network management address of the modem to be changed.
The valid address field range is from 001 to 256.
To increment digits within the address field (xxx), use the and keys to position the cursor
( _ ) under the digit to be incremented. Press the F2 (
") key to increment the digit.
Press Enter (Ent) to implement the function (yyyyyy) you selected (Active, Delete, or Skip). The
message Command Complete appears on the second line of the LCD to indicate that the poll list
change occurred. If the message Poll List Check appears, you attempted to delete an address that
is not on the poll list, or you attempted to add an address that is already on the poll list. If the
message Poll Lst too Big appears, you exceeded the maximum number of downstream devices. To
return to the selected function (Active, Delete, or Skip), press the
key. The address
automatically increments upon returning to this function.
To exit this function (Active, Delete, or Skip) and remain in the PList Change branch, press the
key. To exit and return to the Top-Level menu, press the
key.
Add
The Add function does not appear in Remote mode or on control modems.
Add allows you to add the tributary modem to a control modem’s poll list. This function should be
initiated from only one tributary modem at a time.
To access Add from the Plist branch, make the following selections:
F1
Poll List:
Change
Add
F2 F3
Press the key until Add appears. Select Add.
F1
Poll List:Add
Command Complete
F2 F3