Paradyne 392xPLUS - Manual (Page 198)

AT Command Set and S-Registers
5-13 3920-A2-GN31-30 November 1996
Table 5-2
(8 of 9)
392x Plus AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
&Z n=x Store Telephone Numbers. Modem saves the telephone numbers and dial
command modifiers (if any) entered for
x (up to 40 characters in length) in
Directory Location n (1–24). For example, the command AT&Z1 = 5551234
stores the telephone number 555-1234 into directory location 1.
To clear a telephone number from a memory location, issue the &Z n =x command
without entering a telephone number.
Call Setup\
Change Directory
\A n Maximum Frame Size.
\A0 64 bytes.
\A1 128 bytes.
\A2 192 bytes.
\A3 256 bytes.
\A4 32 bytes.
\A5 16 bytes.
Configure\Edit\
V42/MNP/Buffer
\C n Error Control Negotiate Buffer.
\C0 Disable.
\C1 Enable.
\C2 Disables and switches modem to Buffer mode.
Configure\Edit\
V42/MNP/Buffer
\D n CTS Control.
\D0 Forced On. Forces CTS to always ON.
\D1 Standard RS232.
\D2 Wink When Disconnect. CTS is turned OFF for 1 to 2 seconds upon a
disconnect.
\D3 Follows DTR. The state of CTS follows the state of DTR.
\D4 Follows RTS. The state of CTS follows the state of RTS.
Configure\Edit\
DTE Interface
\G n Modem to Modem Flow Control.
\G0 Disable.
\G1 Enable.
Configure\Edit\
V42/MNP/Buffer
\K n Buffer Control, Send Break Control, Break Forces Escape.
Break Buffer Send Break Break Forces
Control: Control: Escape:
\K0 Discard Data Break First Enable
\K1 Discard Data Break First Disable
\K2 Keep Data Break First Enable
\K3 Keep Data Break First Disable
\K4 Keep Data Data First Enable
\K5 Keep Data Data First Disable
Break Buffer
Control:
Configure\Edit\
V42/MNP/
Send Break
Control:
Configure\Edit\
V42/MNP/Buffer
Break Forces
Escape:
Configure\Edit\
DTE Dialer