Paradyne 392xPLUS User Manual
Page 192
AT Command Set and S-Registers
5-7
3920-A2-GN31-30
November 1996
Table 5-2
(2 of 9)
392x
Plus AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
DS=
n
Dial Stored Number. Dials the number stored in Location
n (1–24). (To store a
telephone number, refer to the &
Zn=x command.)
Call Setup\Dial\
Dial Directory:
E
n
Command Character Echo.
E0
Disables echo to the DTE.
E1
Enables echo to the DTE.
Configure\Edit\
DTE Dialer
H
n
Hook Switch Control.
H0
Modem goes on-hook.
H1
Modem goes off-hook.
H0: Call Setup\
Disconnect or
Control\Remove
Make Busy
H1: Control\ Make
Busy
I
n
Identification.
I
0
Displays product code — 144.
I
1
Displays 3-digit firmware revision number.
I
2
Performs an EPROM check.
Status\Identity
L
n
Speaker Volume.
L0
Selects low volume.
L1
Selects low volume.
L2
Selects medium volume.
L3
Selects high volume.
Control\Speaker
Configure\Edit\
Misc
M
n
Speaker On/Off.
M0
Speaker always OFF.
M1
Speaker ON until carrier signal is detected.
M2
Speaker always ON.
Control\Speaker
Configure\Edit\
Misc
O
Return to Online or Data Mode. Returns modem to Data mode from Online
Command mode.
None
P
Pulse Dial. Sets the modem for Pulse Dial mode.
NOTE: Pulse Mode is disabled in Denmark and Sweden.
Configure\Edit\
Line Dialer
Q
n
Result Codes.
Q0
Enables modem to send result codes to the DTE.
Q1
Disables modem from sending result codes to the DTE.
Q2
Enables in Originate mode only for modem to send result codes to
the DTE. Required for most UNIX
r
applications.
Configure\Edit\
DTE Dialer
S
n=r
Change S-Register. Changes contents of S-Register (where
n is the S-Register,
and
r is the new value).
None
S
n?
Display S-Register. Displays value of S-Register where
n is the S-Register
number.
None
T
Tone Dial. Sets the modem for tone dial mode.
Configure\Edit\
Line Dialer
V
n
Result Codes Format.
V0
Displays result codes in Number (1) format (digits).
V1
Displays result codes as text.
V2
Displays result codes in Number (2) format (digits).
Configure\Edit\
DTE Dialer