Paradyne 392xPLUS - Manual (Page 116)

DCP Operation
3-79 3920-A2-GN31-30 November 1996
F1
Leased:28.8
Control
ExitRem
F2 F3
If the remote modem accepts the password and the entry is successful, the Top-Level menu of the
remote modem appears on the local modem’s LCD. An appears in the upper right-hand corner
indicating that what is displayed on your LCD is actually the Top-Level menu of the remote
392xPlus modem. If the message Remote FP Busy appears, the remote modem’s front panel is
already in Remote mode.
Status
“Status”
Configure PList Control Test SubHS Call_Setup ExitRem
The Top-Level menu of the remote 392xPlus modem is similar to the local 392xPlus modem with
the following exceptions:
•
The Talk/Data and Security branches do not appear.
•
Change Directory is the only function available under the Call Setup branch.
•
Local Analog Loop and Remote Digital Loop do not appear under the Test branch when
using the secondary channel. When using the primary channel, the Test branch does not
appear.
•
Poll List Display is the only function available under the PList branch.
•
Exit Remote replaces Remote on the local modem’s LCD.
To return to local modem operation, select ExitRem. Any changes made to configuration options in
the remote modem are saved.
The following conditions can cause Remote branch access to fail:
•
The local modem is not able to communicate with the remote modem because of a poor dial
network or leased-line connection, or the remote modem is not a 3900 Series modem. If this
is the case, the status message No Response appears on the LCD.
•
If a connection is established but the remote modem’s Access from Remote configuration
option is disabled, then the status message Access Disabled appears on the LCD.
•
If a connection is established but the wrong password is stored, the status message
Password Invalid appears on the LCD. This configuration option must be enabled by the
remote user. (Refer to the Remote Access Password configuration option in Chapter 4.)
•
The remote mode command displays Other Test Active if an Analog Loopback test is
currently running.