Paradyne 392xPLUS - Manual (Page 206)

AT Command Set and S-Registers
5-21 3920-A2-GN31-30 November 1996
Table 5-3
(6 of 12)
392x Plus S-Registers
S-Register
DCP LCD
Command
Sequence
Description
S52 DTE LL (CT141). Register determines if the modem performs a local analog
loopback if it receives a CT141 signal from the DTE.
Register has the following values:
0 = Disable
1 = Enable
The factory setting is Disable.
Configure\Edit\
Tests
S53 V.54 Address. Identifies the address of the modem to be placed in a loopback
test.
Register has the following values:
0 = Disable
1–34 = Modem address
The factory setting is Disable.
Configure\Edit\
Tests
S54 V.54 Device Type. Identifies where the modem is physically located in the
network.
Register has the following values:
0 = Peripheral
1 = Intermediate
The factory setting is Peripheral.
Configure\Edit\
Tests
S55 Access From Remote. Register determines if a modem’s DCP can be
accessed by a remote modem.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
Configure\Edit\
Misc
S56 Remote Access Password. Register allows entry of the first pair (leftmost) of
digits of a remote access password. Any value from 00 to 99 is valid. For
example, if the remote access password is 12345678, then S56 = 1 and 2. Configure\Edit\
Misc
S57 Remote Access Password. Register allows entry of the second pair of digits of
a remote access password. Any value from 00 to 99 is valid. Configure\Edit\
Misc
S58 Remote Access Password. Register allows entry of the third pair of digits of a
remote access password. Any value from 00 to 99 is valid. Configure\Edit\
Misc
S59 Remote Access Password. Register allows entry of the fourth pair (rightmost)
of digits of a remote access password. Any value from 00 to 99 is valid. Configure\Edit\
Misc