Polycom Webcam - Manual (Page 37)

Chapter 2 - Installing the ViewStation EX
© Polycom, Inc. 2003 35
ISDN Network Interface Modules
This section explains how to install the following ISDN network
interfaces:
❑
V.35/RS-449/RS-530. See Setting up the V.35/RS-449/RS-530
Network Interface on page 35 .
❑
BRI. See Setting up the Quad BRI Network Interface on page 38 .
Setting up the V.35/RS-449/RS-530 Network Interface
This section explains how to install and connect the
V.35/RS-449/RS-530 network interface module so that you can
make calls over ISDN with the system.
The V.35/RS-449/RS-530 network interface supports the V.35,
RS-449, or RS-530 protocol depending on the cable you use to
connect your equipment.
Connecting a V.35/RS-449/RS-530 network interface module to
your system:
1. Make sure your system is turned off.
2. Insert one end of the light blue keyed cable into the light blue
port on the back of the system. The cable has special RJ-45
connectors that are not interchangeable with normal RJ-45
connectors.
3. Insert the other end of the light blue RJ-45 cable into the input
port labeled
x on the network interface module.