Do ff at tof, Igp 100 compatibility, Ignore character – Printronix T4204 User Manual

Page 110: Ignore mode, Select character, Error report

Advertising
background image

110

Chapter

3

IGP/PGL Emulation

Do FF at TOF

Determines whether the printer, with media already set at the TOF (Top-of-
form) position, will advance media to the next TOF position upon receipt of a
FF command.

Enable. The printer will advance media from the present TOF position to
the next TOF position upon receipt of a FF command, causing a blank
form.

Disable. The printer will not advance media from the present TOF
position to the next TOF position upon receipt of a FF command.

IGP 100 Compatibility

This parameter forces the output to correspond with IGP-100 printer output in
cases where there are differences. The default is disable.

Ignore Character

Ignore Mode

This parameter instructs the PGL to ignore the character selected under the
Select Character menu.

Disable. The PGL does not ignore any characters.

Enable. The PGL ignores the character specified in the Select Character
menu.

Select Character

Instructs the PGL which decimal character (0-255) to ignore from the host.

Error Report

Sets the error reporting capability on the printer for PGL forms.

On. Null error boundry checking is reported (printed). Any element that
cannot fit on the current page is reported (printed) as an error message.

Debug Mode. Each line of the CREATE form will be printed along with an
error message if one occurred. It has the same functionaility as when a
slash was entered in the command before the CREATE form name.

Fault. The printer will halt if an IGP/PGL error occurs. When “Fault” is
selected, the IGP/PGL error will be printed and the message “IGP/PGL
Error” will be displayed on the front panel, followed by the printer going
offline.

Off. No label boundry checking takes place. Graphics elements such as
alpha, line, barcodes etc. will be printed and clipped if they exceed the
page boundaries.

Advertising