Printronix T4204 - Manual (Page 162)

162
Chapter 3 Coax/Twinax Emulation
Host Override
Determines whether the printer accepts certain commands sent by the host,
or continues to use the current operator panel settings.
• Disable. Allows these host commands to override operator panel
settings: line length, forms length, lines per inch (LPI), characters per inch
(CPI), print quality, and text orientation. Note the information appearing on
the message display may not match the data stream setting. No values
will change upon initial selection of the disable option.
• Enable. The operator panel settings override the host commands.
NOTE: Host margin and tab settings will take precedence, whether or not
Host Override is enabled.
Format Control
Enables the printer to reflect the same spacing as CTPC model printers after
absolute and relative move commands are executed.
• Disable. Reflects distance, generated by the IGP/VGL feature, IGP/PGL
feature, and Hex Transparent control code sequence, in the new position
(after absolute and relative move commands are executed).
• Enable. Does not reflect distance, generated by the IGP/VGL feature,
IGP/PGL feature, and Hex Transparent control code sequence, in the
new position (after absolute and relative move commands are executed).
Max. Print Width
Set the maximum print width.
• 13.2 inches
• Printer Width (the width of the T4204, or 4.10 inches)
Buffer Print
• Disable. The printer will print normally.
• Enable. The printer prints the EBCDIC data and control codes received
from the host as hex values.
NOTE: Use of this parameter may alter print attributes set by the host
computer. A power cycle may be required after changing Buffer Print
from enable to disable.