Printronix T4204 - Manual (Page 195)

Fault Messages
195
Operator-Correctable Fault Messages
For the operator-correctable faults, follow the suggested corrective action
under the solution section of the table. After correcting the displayed fault,
press the CLEAR key to clear the error message and status indicator and
resume printing. If the fault message reappears, contact your authorized
service representative.
NOTE: The Maintenance Manual provides more detailed information and
procedures for resolving fault conditions. However, many of the
procedures described there must be performed only by your
authorized service representative
.
Fault Messages Requiring Field Service Attention
If a fault is not correctable by the operator, the fault message is followed by an
asterisk (*). This usually indicates that an authorized service representative is
needed. You may try two steps to clear the fault before calling your authorized
service representative:
1. Set the printer power switch to O (off), wait 15 seconds, then turn the
printer on again. Run your print job again. If the message does not
appear, it was a false indication and no further attention is required.
2. If the message reappears, press the CLEAR key. If the message goes
away, it was a false indication and no further attention is required. If the
message reappears, call your authorized service representative.