Printronix T4204 - Manual (Page 96)

96
Chapter 3 Menu Options
Tear-Strip Time
When using Tear-Off Strip media handling, the Tear-Strip Time option
specifies the number of seconds after the buffer is empty that the printer will
wait before it advances media to the tear off position.
Clip Page
This option determines how the printer handles images that are too large for
one physical page length.
• Disabled. When the user selected page length is greater than the
physical page length, the printer continues to print the remaining excess
data onto the next physical page. The media sensor looks for the gap
notch, hole, or black mark only after the label has advanced the distance
specified by the Page Length value in the Printer Control menu, or by the
host forms Length value sent via host software. Any gaps, holes, notches,
or black marks that exist prior to reaching the Page Length or Host Forms
Length value will be ignored.
• Enable. When the user selected page length is greater than the physical
page length, the printer clips the excess data to fit the physical page. The
excess data is lost. The media sensor will constantly look for the gap,
notch, hole, or black mark, and when detected will use it as the Top-Of-
Form Position for the next page and clip any excess data for the previous
page.
Error Recovery
This option determines how the printer handles data that was printing when
an error occurred.
• Disabled. The printer will not reprint the label that was printing when the
error condition occurred.
• Enable. The printer reprints the label that was printing when the error
condition occurred.