Removal and installation – Printronix T4204 User Manual
Page 184
Advertising
184
Chapter
4
IEEE 1284 Parallel Interface
Table 10 lists the three terminating resistor configurations you can install:
Removal And Installation
The procedure for removing and installing terminating resistors is provided in
your
Maintenance Manual.
IMPORTANT
This is an involved maintenance procedure; only a trained technician
should perform this procedure.
Table 10. Terminating Resistor Configuration
Configuration
Pull-Down (RP1)
Pull-Up (RP2)
Factory Default
1K ohm
470 ohm
Alternate 1
330 ohm
220ohm
Alternate 2
none
1K ohm
Advertising