Printronix T4204 - Manual (Page 46)

46
Chapter 2 Label Peel Off
9. Press the FEED key until the label liner is taut.
10. For automatic label peel-off mode, set Media Handling to Peel-Off in the
configuration menu. The Media Handling submenu is located in the
PRINTER CONTROL Main Configuration menu. See Chapter 3 for more
information on configuring the printer.
Close the printer’s front door and top (and side) cover.
Legend:
1) Peeled Label Area
11. Press the PAUSE key to place the printer Online.
12. Press the FEED key. A label should advance to the peel-off position
under the label taken sensor gate and “LABEL PRESENT Remove Label”
should be displayed.
NOTE: While printing a print job, do not press the FEED key with the ‘LABEL
PRESENT Remove Label’ message displayed or the message will be
removed until the PAUSE key is pressed. Also, each pressing of the
FEED key will cause a blank label to be added at the end of the print
job.
13. Remove the label. “ONLINE” should then be displayed.
NOTE: A problem where labels drop back down onto the liner before they
can be manually removed can occur, causing the label taken sensor
to falsely sense the label was removed. Labels of 1.0 to 1.5 inches
long are more likely to demonstrate this condition.
This problem can be resolved by decreasing Print Speed or Setting
Paper Feed Shift (under the PRINTER CONTROL menu) from 0.00
inches to a negative (-) 0.07 to 0.10 inch value to retract the label
back slightly keeping it in the horizontal position under the sensor.
Peel-Off Mode
1