Printronix T4204 - Manual (Page 115)

IGP/VGL Submenu
115
• Enable. Selects the ignore mode as the power-up default, and selects the
graphics mode ^PY as the power-up default. All characters are ignored
until a ^A command is received.
Power Up ^F
• Disable. The default.
• Enable. Selects free format mode as the power-up default, and selects
the graphics mode ^PY as the power-up default. Free format causes the
VGL to ignore carriage returns, line feeds and all characters below hex 20
sent from the host.
Power Up ^PY
• Disable. The default.
• Enable. Selects the graphics mode ^PY as the power-up default.
Page Format
LPI
• Range of 6-10 lines per inch (lpi), with 6 being the default.
Btm Margin Ctl
• Determines the page’s bottom margin. If this option is set to VGL Text
Length, then Text Length changes the bottom margin value in the LP+
sub-menu as follows: bottom = physical page length-top margin-text
length. If the option is set to LP+ Menu, then a change in text length has
no effect and the bottom margin setting in the LP+ menu will be used
although the new text length value still shows in the menu.
Text Length
• Is the printable length on the page below the top margin. It is in character
lines at the lpi in effect when the new value is entered.
Autoeject
• Determines paper handling upon exiting the IGP/VGL Repeated Form
and Dynamic Form commands. DISABLE holds the print position at the
bottom of the form. ENABLE issues a form feed after the last form is
printed so all pages will be physically printed.
Copy Count
• Determines the number of identical copies of each physical page that will
be printed.
Host Forms Length
• Sets the printer page size. DISABLE sets the printer page size equal to
the Page Length set in the front panel under the PRINTER CONTROL
menu. ENABLE sets the printer page length equal to the software host
form length.