Printronix T4204 - Manual (Page 160)

160
Chapter 3 Coax/Twinax Emulation
Device Address
Allows you to set the device address from 0 through 6. The host directs data
and commands on the twinax line to a specific device based on its unique
device address. After the address has been changed, a POR status is sent to
the host.
5225 World Trade
The 5225 emulation has a standard multinational character set that serves as
a base and 14 extended world trade character set assortments.
Cancel IGP/DCU
• Enable. Cancels all buffers when a job is put on hold from the host, or the
CANCEL key is pressed.
• Disable. Does not cancel any internal buffer in the printer when a job is
put on hold from the host, or the CANCEL key is pressed.
PTX Transparent
Lead-in Char.
You can enable additional features that are not available in standard Twinax
emulations. To access these features, send text commands in the data
stream. The commands must have a start and end code. Three sets (each
containing a start and end code) are available:
• Set 1. start code: <%
end code: >
• Set 2. start code:
¬¬
end code: $
• Set 3. start code: _%
end code: _
Alt. Set 80-9F
• Printable. Prints data in the range of hex 80 through hex 9F.
• Control Code. Interprets data in the range of hex 80 through hex 9F as a
control code.