Polycom KIRK KWS6000 - Manual (Page 24)

KIRK Wireless Server 6000 Installation and Configuration Guide
2–8
Electrical Requirements
The following electrical requirements must be met:
• Power consumption: 8V/500 mA
• Typical power consumption: 5W per unit
• The supplied power for the AC adaptor power supply must be 110 to 240
ac nominal, 50/60 Hz.
• Power supply must be LPS
KIRK Base Stations and KIRK Repeaters
Environmental Requirements
• Avoid installing base stations and repeaters on large concrete or marble
columns because these columns affect radio coverage. If possible, place the
base station a minimum of one meter/3.3 feet from these types of columns.
• Do not install a base station or repeater with the antenna housings near
metal objects. Be careful not to damage existing wiring or panels.
• Do not position base stations and repeaters in ducts, plenums, or hollow
spaces used to transport environmental air except where the duct, plenum
or hollow space is created by a suspended ceiling having lay-in panels.
When you need more than one base station in a cell to meet traffic
requirements, position the base stations at the same cell center.
• Keep the base station and repeater away from steel constructions.
• Do not position base stations and repeaters directly on metallic surfaces. If
possible, place the base station a minimum of one meter/3.3 feet from
these types of surfaces.
• Do not position base station and repeaters behind furniture.
• Only position base stations and repeaters where the signal is needed.
• The installation area must be clean, free of traffic and excess dust, dry, and
well ventilated.
• The installation area must be within the temperature ranges of 10°C and
40°C/50°F and 104°F.
• The installation area must be between 20% and 80% non-condensing
relative humidity.