Polycom KIRK KWS6000 User Manual
Page 79
Preparing KIRK Handset for Use
8–5
This section describes how to install the battery on a 4020/4040/4080 Handset.
1
To change the battery unscrew the plate on the rear of the handset to
access the battery compartment. Use a normal screw driver.
2
Insert the screwdriver into the small crack behind the blind cover and
break to open the handset.
Figure 8-1
Remove Back Cover from Handset with Screw Fastener
3
Place the battery plug in the slot in the battery box.
4
Insert battery with the label readable.
5
Replace the back cover.
Installing Battery on KIRK 5020 and KIRK 5040 Handsets
This section describes how to install the battery on a 5020 Handset.
1
To install the battery press down the back cover and slide it towards the
bottom of the handset.
Figure 8-2
Remove Back Cover from Handset
2
Lift off back cover.