Panasonic AJ-HDX400P - Manual (Page 50)

Chapter 4 Adjustments and settings for recording
50
4
Turn the JOG dial button to move the arrow (cursor) to
the “TITLE : ” item.
5
When the JOG dial button is pressed, the arrow (cursor)
moves to the title input area, and the input mode is
established.
7
Press the JOG dial button to enter the character.
8
Turn the JOG dial button to move the arrow (cursor) to
the next position (right), and repeat steps 6 and 7 to set
the characters (maximum of 8).
Giving a title to the selected file
6
Press the JOG dial button again and turn it until the
character to be set is displayed.
When the button is turned, the character displayed is
switched in the following sequence:
Space: ∑
7
letters: A—Z
7
numbers: 0—9
7
symbols: ’, >, <, /, –
< CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
# TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
< CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
;
10 When the JOG dial button is pressed, the arrow (cursor)
returns to the TITLE: item.
11
Turn the JOG dial button to move the arrow (cursor) to
the WRITE item.
12 When the JOG dial button is pressed, the following
message appears.
9
When the title has been input, turn the JOG dial button to
move the arrow (cursor) to the “:” position.
Saving the data settings to the selected file
< CARD READ/WRITE >
R.SELECT 1
READ
W.SELECT 1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
;
WRITE?
YES
# NO
TITLE:
If one of the following messages appears when the JOG dial button is
pressed, the data cannot be saved.
Error message Remedial action
WRITE NG NO CARD
(setup card has not been inserted) Insert the card.
WRITE NG FORMAT ERROR
(formatting error) The card was formatted by a device
other than the unit.
Replace the card.
WRITE NG ERROR
(the data cannot be saved) The card may be defective.
Replace it.
WRITE NG
WRITE PROTECT Remove the card to cancel write
protect.