Panasonic AJ-HDX400P - Manual (Page 65)

Chapter 5 Preparation
5
65
5-3-3 When using a wireless receiver
When using a UniSlot ® wireless receiver
5-3-4 When using an audio component
1
Connect the AUDIO IN connectors on the camera with
the audio component using the XLR cable.
1
Remove the slot cover, insert the wireless receiver, and
screw it down.
2
Set the AUDIO IN switch or switches for the channel or
channels to which the audio component has been
connected to “REAR.”
2
Set the AUDIO IN switches to WIRELESS for the audio
channels whose audio signals are to be recorded.
3
Set the LINE/MIC/+48V selector switch on the rear panel
to “LINE.”
AUDIO IN connectors
AUDIO IN switches
LINE/MIC/+48V
selector switch
1
Mount the tripod attachment on the tripod.
<Note>
Take account of the center of gravity of the unit and that of the
tripod attachment when selecting the attachment hole. Check
that the diameter of the hole selected matches the diameter of
the tripod head screw.
2
Mount the unit on the tripod attachment.
Tripod head
Tripod attachment
5-4 Mounting the unit on a tripod
Use the tripod attachment to mount the unit on a tripod.
Tripod attachment
Slide the unit along the groove toward the front until it clicks
into place.
Detaching the unit from the tripod attachment
Red lever
While pushing down the red lever, move the black lever in the
direction of the arrow and slide the unit toward the back to
remove it.
<Note>
If the pin of the tripod attachment fails to return to its original
position after the unit has been detached, again move the
black lever in the direction of the arrow while pushing down
the red lever, and return the pin to its original position. Bear
in mind that the unit cannot be attached if the pin remains in
the center.
Black lever