Oceanic Personal Dive Computer Veo 100Nx - Manual (Page 53)

53
RESET (CLEAR) FEATURE
The Veo 100Nx is configured with a RESET feature that allows data to be cleared, including Nitrogen
and Oxygen calculations and Log Mode entries.
WARNING: Reset after a dive and subsequent use for a repetitive dive con-
ducted by the same diver could result in serious injury to or death.
RESET PROCEDURE
 While the Surface Sequence is scrolling, press/release the button to access the Log Mode
displaying the first screen (Dive Preview/Identifier) of the most recent dive.
 Press/release the button again to access the second screen (Dive Data) of the most recent dive.
 Depress/hold the button while the second Log screen of the most recent dive is being displayed to
access the Reset screen. The graphics CLR and id will appear with the Key Code 01 01, the first
2 digits flashing (Fig. 62). Release the button.
 If necessary to change the first 2 digits, press/release the button repeatedly to advance to the
correct number.
 Depress the button for 2 seconds to save the first 2 digit number and
advance to the second 2 digits, flashing.
 If necessary to change the second 2 digits, press/release the button
repeatedly to advance to the correct number.
 Once the proper Key Code has been entered (01 01), depressing
the button for 2 seconds accept the Key Code, complete the Reset
operation, and turn the unit Off (i.e., Clearing it).
 If an incorrect Key Code number has been entered, the unit will revert
to the Surface Sequence when the button is depressed, resuming
previous operation(s).
Fig. 62 - RESET (Clear)