Oceanic Personal Dive Computer Veo 100Nx - Manual (Page 59)

59
Battery Hatch Removal
 Locate the Battery Compartment on the back of the Module.
 While applying steady inward pressure on the center of the
Battery Hatch, rotate the Hatch Retaining Ring 10 degrees
clockwise using a flat blade screwdriver (Fig. 64) or a
Battery Hatch Tool.
 Lift the Hatch Ring up and away from the Housing, or turn
the Module over to allow the Ring to drop out into your
hand.
 Remove the Battery Hatch.
Battery Removal
 Remove the Retaining Bar located across the lower portion of
the Battery (Fig. 65a).
 Remove the Hatch O-ring. DO NOT use tools
 Using care not to damage the Battery Contacts (Fig. 65b/c),
slide the Battery up and out of the Battery Compartment.
Inspection
 Closely check all of the sealing surfaces for any signs of
damage that might impair proper sealing.
 Inspect the Button, Lens, and Housing to ensure they are not
cracked or damaged.
Fig. 64 - RING REMOVAL
Fig. 65 - HATCH REMOVAL
a
b
c