Oceanic Personal Dive Computer Veo 100Nx - Manual (Page 62)

62
Inspection
 Activate the unit and watch carefully as it performs a full
diagnostic and battery check, and enters Surface Mode.
 Observe the LCD display to ensure it is consistently clear and
sharp in contrast throughout the screen.
WARNING: If there are any portions of the display
missing or appearing dim, or if a Low Battery condi-
tion is indicated, return your Veo 100Nx to an Autho-
rized Oceanic Dealer for a complete evaluation before
attempting to use it.
RETURNING THE MODULE TO BOOT
 If the Boot was fitted with a Spacer and it was previously
removed, replace the Spacer into the Boot.
 Orient the Module over the opening in the Boot, and dip the
bottom edge into it while pressing the top edge with the palm
of your hand. Stop pressing when the bottom edge of the
Module has just entered the Boot.
 Correct the alignment of the Module as needed so that it is
straight.
 Press the Module completely into place with your thumbs,
watching the alignment, until it snaps into place.
Responsible