Oceanic Personal Dive Computer Veo 100Nx - Manual (Page 61)

61
 Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch (Fig.
68). Ensure that it is evenly seated.
 Slide the Hatch Retaining Ring, top portion first (small
opening), onto your thumb.
 Carefully place the Battery Hatch (with O-ring) into posi-
tion on the rim of the Battery Compartment, then press it
evenly and completely down into place with your same
thumb.
 Maintain the Battery Hatch securely in place and, using
your other hand, slide the Retaining Ring down off your
thumb and into position around the Battery Compartment.
 The tabs on the Retaining Ring fit down into the two slots
located at the 2 and 8 o'clock positions.
 Using your fingers, turn the Ring counter clockwise 5
degrees until the tabs engage (Fig. 69), then tighten it 5
more degrees by turning it counter clockwise using the
Battery Hatch Tool (Fig. 70).
 While tightening the Retaining Ring, exert continuous
inward pressure on it until it is secured in the proper
position. A small symbol located on the Ring should be
aligned with the Locked symbol located on the Housing
(Fig. 70a)
Fig. 68 - O-RING ORIENTA-
TION
Fig. 70 -TIGHTENING the
RETAINING RING
Fig. 69 -ENGAGING the
RETAINING RING TABS
a