Tunturi R60 - Manual (Page 10)

10
OWNER
'S
M
ANU
AL
• R
60
IMPORTANT!
The device is shipped with a loop
and a hook for securing the rowing machine
properly in the storage position. Choose
an appropriate storage site for your rowing
machine next to a wall and attach the hook
tightly to the wall at the right height. Lift the
rowing machine to the storage position in
front of the hook. Thread the loop provided
with the rowing machine around the cross
bar and attach the loop to the hook. Do not
climb on the rowing machine when it is in
storage position!
MAINTENANCE
• The R60 requires very little maintenance.
Check, however, from time to time that all
screws and nuts are tight.
• Clean the cycle with a damp cloth. Do not
use solvents.
• Never remove the protective covers.
• Clean the inner surfaces of the rail if
necessary so that the seat moves as
smoothly and quietly as possible. If
necessary, you may improve the seat
movement by adding paraffin to the surface
of the rails.
BATTERY REPLACEMENT
Meter batteries: A warning display reports
when the batteries of the meter need to be
replaced. Turn the meter carefully outward
from the front frame so that you can remove
the battery box cover on the back of the
meter. Open the battery box cover carefully
from its lower edge. Be careful not to
damage the wires. Replace the batteries (4
“C” batteries) in the battery box according to
the markings. Replace the cover.
Pull-bar battery: If the pull-bar controls
cease to respond completely, replace the
battery (3V lithium cell CR2032). Open the
cover of the battery box on the back of the
pull bar by removing the attachment screw.
Replace the battery; make sure you place
it in the right direction inside the holder.
Replace the cover.
MALFUNCTIONS
Despite continuous quality control, defects
and malfunctions caused by individual
components may occur in the equipment.
In most cases it’s unnecessary to take the
whole device in for repair, as it’s usually
sufficient to replace the defective part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and
serial number of your equipment. Please
state also the nature of the problem,
conditions of use and purchase date.
If you require spare parts, always give the
model, serial number of your equipment and
the spare part number for the part you need.
The spare part list is at the back of this
manual. Use only spare parts mentioned in
the spare part list.
TECHNICAL SPECIFICATIONS
Length...................................200 cm
Width .....................................48 cm
Height ....................................56 cm
Weight ....................................46 kg
The R60 meets the requirements of the
EU’s EMC Directives on electromagnetic
compatibility (89/336/EEC). This product
therefore carries the CE label.
The R60 meets EN precision and safety
standards (EN-957).
Due to our continuous policy of product
development, Tunturi reserves the right to
change specifications without notice.
NOTE!
The instructions must be followed
carefully in the assembly, use and
maintenance of your equipment. The
warranty does not cover damage due to
negligence of the assembly, adjustment and
maintenance instructions described herein.
Changes or modifications not expressly
approved by Tunturi Oy Ltd will void the
user's authority to operate the equipment!
We wish you many enjoyable trainings
with your new Tunturi training partner!