TechniSat S1 - Manual (Page 11)

cable. If your television set is appropriately equipped,
it will switch automatically to AV when the digital recei-
ver is switched on, and will provide satelliote recep-
tion.
4.3.2 Via HF cable
If your television set is not equipped with a SCART socket,
the digital receiver will have to be connected to the antenna
input socket of the television set. If this connection is used,
only mono sound reproduction is possible.
To make the connection, proceed as follows:
e
Use a suitable TV connection cable to connect the
receiver (
HF output) to the antenna input socket of
the television set.
f
Connect the cable coming from the terrestrial antenna
to the
Terrestrial antenna input of the digital
receiver.
You must now set your television set to the transmission (out-
put) channel of the digital receiver. Select a free programme
slot on your television set, and tune it to Channel 38 (if
necessary, consult the operating manual of your television
set).
If you do not receive a clear picture on Channel 38, either
this channel or a neighbouring channel may already be tuned
to a programme being received via the antenna. You can
check on this by temporarily removing the antenna cable
from the
Input terrestrial antenna socket of the digital
receiver. If you then temporarily receive a clear picture, you
should select a different channel on the digital receiver, in the
range 21 to 69.
Setting the UHF output channel
To set an optimum UHF output channel, please proceed as
described in 6.3, and go to the menu
Audio/Video
Settings and mark the field UHF output channel. Then
proceed as described in 6.3.7.
4.4 Video cassette recorder (VCR)
g
Connect the video recorder to the SCART socket mar-
ked
VCR. In Playback mode, the video recorder will
supply a switching signal to the digital receiver. The
video recorder signal will be sent automatically to the
TV set.
If your video recorder does not supply the required
switching current, use the
0/AV key to switch your
digital receiver to the external input
AV. Press this key
again to return to normal operation.
4.5 HiFi Amplifier
4.5.1 Analogue
11
Bed_anl_.qxd 20.02.04 16:28 Seite 11