TechniSat S1 - Manual (Page 7)

7
3 Please read this first
> Before operating your unit for the first time, please
check that you have received all the components. The
package should contain:
1 digital receiver, 1 mains power cable, 1 remote con-
trol, 1 operating manual, 1 guarantee card, 2 batteries
(1,5V microcell).
> Insert the batteries supplied in the battery compartment
of the remote control unit, taking care to observe the
correct polarity.
> Before connecting you digital receiver, please first read
the safety notes in
Chapter 3.
>
Chapters 4, 5 and 6 describe how you should con-
nect and adjust the digital receiver to the external unit
(antenna dish, LNC, ...), to the television set, VCR, etc.
These settings need only be made once, and would
only have to be updated if there is any change in your
external unit, or if additional pieces of equipment are to
be connected.
>
Chapter 7 describes all the functions important in
everyday use, e.g. programme selection or operating
the hard drive.
> In
Chapter 8 you will find information on how to set
new programmes, or how to change the order of pro-
grammes in the list.
>
Chapter 9 describes the settings to be made when
operating a rotating antenna.
> Technical terms used in the operating manual are
explained in
Chapter 10.
> Technical data is set out in
Chapter 11.
> A brief troubleshooting guide can be found in
Chapter
12.
Important notes on operating the unit
The implementation of an "On Screen Display" (text shown on
screen) helps to simplify thed operation of the digital receiver,
and also helps to reduce the number of kews required on the
remote control unit. All functions are indicated on the screen,
and can be implemented with a few keys. Related functions
are combined in a "MENU". The function selected will be mar-
ked and highlighted in a different colour. The bottom line of the
display shows colour bars in green, red, yellow and blue, corr-
responding to the function keys in these colours. In the various
menus these colour bars represent different functions which
can be accessed by pressing the multi-function key of the
appropriate colour on the remote control unit. The function
keys are only active if a brief description appears in the appro-
priate field.
Key descriptions and other terms appearing in the OSD menu
Sehr geehrte Kundin, sehr geehrter Kunde,
Bed_anl_.qxd 20.02.04 16:28 Seite 7