TechniSat S1 - Manual (Page 56)

This menu item allows you to access the sub-menues of the
CI module inserted. By confirming with
OK, you can display
information relating to the CI module inserted as well as to
the smart card being used.
Manual initialising of the CI module
>
You can initialise the CI module manually by pressing
the
red function key CI Reset.
9 Operating a rotary antenna installation
(DiSEqC 1.2)
Your digital receiver is ready to operate a motorised rotary
antenna installation The DiSEqC control function (DiSEqC
level 1.2) allows you to control a suitable motor via the co-
axial cable.
>
Call up the menu
Antenna settings as described
under Point 6.4 (Fig. 9-1) and switch the
DiSEqC
control (Point 6.4.1) to on.
> Now use the
up/down arrow keys to select the
DiSEqC position (e.g. A/B 3) to which you wish to
allocate the motorised antenna.
> Press
OK to open a window allowing you to select a
Satellite resp. the option Motor antenna. (Fig. 9-
2)
> Use the up/down arrow keys to select the line
Motor
antenna and confirm by pressing OK.
> Confirm the screen prompt (Fig. 9-3) regarding the
setting or Eastern and Western limits by pressing
OK.
9.1 Eastern and Western limits
To avoid potential mechanical damage to the dish antenna or
the LNC by any obstacles, you must first determine the
maximum range of movement/rotation in both an easterly and
westerly direction. If there are any obstacles within the
rotating range of the antenna, such as walls or
chimnies,these must definitely be considered when setting
the easterly and westerly limits.
If there are no obstacles within the rotating range of the dish,
then set the limits of the rotation in such a manner that the
dish can move a little further than is strictly speaking required
to receive signals from the most extremely positioned
satellites.
9.1.1 Deleting existing limits
You should first of all delete any existing limit settings.
>
Use the
left/right arrow keys to mark the column
LNC test.
> In the line
Motor antenna use the up/down
arrow keys to mark the field Continue.
56
(Fig. 8-16)
(Fig. 8-15)
Bed_anl_.qxd 20.02.04 16:29 Seite 56