TechniSat S1 - Manual (Page 20)

arrow keys to move forward or back one page at a
time.
If the satellite you are looking for is not shown in the
list, please select one of the reserve slots, marked
User 1 to User 14.
> Confirm by pressing
OK. The selected satellite will
now be inserted at the previously selected position in
the menu
Antenna settings.
Continue to work in the menu
Antenna settings in this
manner until the settings in this menu correspond fully with
those of your reception installation. Select the option
No
Satellite for any switching criteria not required.
6.4.3 Additional settings/LNC characteristics
When you have completed adjsuting the switching matrix of
your DVB receiver to match the reception installation, you
should check the additional settings for your reception instal-
lation, and adjust them where necessary.
>
Use the
left/right arrow keys to move the marker
to the column
Configuration.
> Now use the
up/down arrow keys in the line in
which you want to check or adjust the settings, and
press
Next.
> Confirm by pressing
OK.
A sub-menu will be displayed in which you can adjust
LNC settings, and set up a test transpon der. (Fig. 6-9)
The following adjustments may be made:
LNC type
>
In this line use the
left/right arrow keys to enter the
type of LNC you are using. You can choose from
Single LNC, Quatro LNC, DisiCon 1 LNC,
DisiCon 2 LNC, DisiCon 4 LNC, C-Band LNC
and a
User LNC for manual entry of LNC data.
> Press
OK to accept the setting into memory.
Test Transponder
The following points of this menu need only be entered if you
wish to check the satellite signal of a particular satellite.
Transponder frequency
In this line, use the
numeric keys to enter a frequency on
which digital programmes are broadcast.
Polarisation
Use the
up/down arrow keys to select the appropriate
polarisation plane (
horizontal or vertical).
Symbol rate
The symbol rate indicates the volume of data transmitted per
second. This could be, for instance, 27500 (27500 symbols
per second). Use the
numeric keys to enter the appropriate
symbol rate.
20
Bed_anl_.qxd 20.02.04 16:28 Seite 20