TechniSat S1 - Manual (Page 12)

To achieve the best possible sound quality, you may connect
the digital receiver to a HiFi amplifier. To do this, use a suita-
ble cable to connect the cinch sockets
Audio R and Audio
L of the digital receiver with an input on your HiFi amplifier
(e.g. CD or AUX; please note that the Phono input is not sui-
table!).
4.5.2 Digital
Should your amplifier be equipped with an appropriate electri-
cal or optical input, you may connect the sockets
AUDIO
OUT DIGITAL elektrical resp.. AUDIO OUT DIGITAL
optical with the electrical resp. the optical input of your
amplifier.
Depending on the channel selected, sampling rates of 32,
44,1 and 48 kHz are available.
Where broadcast, the Dolby Digital-Signal (AC3) is also avai-
lable at this output.
4.6 Unit with S-Video input (Hosiden)
h
To connect the
S-Video output with a unit equipped
with an S-Video input (e.g. beamer etc.).
4.7 Serial Interface (RS 232)
The RS 232 interface serves to carry out pre-programming
via a PC, and to update the operating software.
5 Initial installation
Once you have read the safety notes, and have connected
the unit as described in Chapter 4, you may switch on the unit
as described in Chapter 7. When the unit is switched on for
the first time, the start window of the installation assistant is
displayed:
AutoInstall. (Fig. 5-1) The installation assistant
will help you to make the most important settings on your
digital receivers quickly and simply.
To make the adjustments in each step of the installation, the
remote control keys required are indicated.
You can exit from the initial installation procedure at any time
by pressing the
red function key. Press the green function
key to return to the previous step of the installation. You can
thus correct any mistakes made at any time.
If the initial installation is not carried out, or is aborted before
completion, the unit will commence operation with a standard
pre-programmed configuration.
The initial installation described here serves only as an
example. The exact procedure of the intial installation will
depend on the settings you choose to make.
Please follow closely the instructions given on the screen.
12
Bed_anl_.qxd 20.02.04 16:28 Seite 12