TechniSat S1 - Manual (Page 36)

display.
3. Programme change timer
If your receiver is in normal operating mode, it will switch to
the pre-selected programme slot at the designated starting
time. In contrast to the hard drive or video recorder timers,
the full functionality of the unit is not restricted, and the unit
will not be switched off at the end of the programme.
Manual timer programming
> Press the
Menu key to call up the Main Menu.
> Use the
up/down arrow keys to mark the line
Timer management.
> Confirm by pressing
OK.
The sub-menu
Timer management will be display-
ed. (Fig. 7-23)
> Use the
up/down arrow keys to select the type of
timer you wish to programme.
> Press
OK. A new window will be displayed, allowing
you to enter the programming data for a new timer
event. (Fig. 7-24)
To prgramme an event proceed as follows:
Source
>
Use the
arrow keys to mark the column Source.
> Press
OK.
> A selection window will be displayed. Use the
up/down arrow keys to select the desired source
(
TV or Radio).
> Confirm by pressing
OK.
Depending on the previous setting, either the TV or
the radio programme list will now be displayed.
> Use the
arrow keys to mark the desired programme.
> Use the
up/down arrow keys to move the marker
around the list one line at a time.
> Use the
left/right arrow keys to move back-ward or
forward in the list one page at a time.
> Press
OK to accept the selected programme into the
timer.
Date
>
Use the
arrow keys to mark the column Date.
> Use the
numeric keys to enter the date (4 digit form)
of the timer event.
Start
>
Use the
arrow keys to mark the column Start.
> In this line, use the
numeric keys to enter the star-
ting time for the timer.
Stop
>
Repeat the steps as set out under “Start” to enter the
stop, or ending time (except for programme change
36
(Fig. 7-21)
(Fig. 7-22)
(Fig. 7-20)
Bed_anl_.qxd 20.02.04 16:29 Seite 36