TechniSat S1 - Manual (Page 38)

> Press the
green function key Delete.
A prompt will be displayed:”Do you really want to dele-
te this timer?”
> Use the
left/right arrow keys to select Yes.
> To delete the timer entry confirm by pressing
OK.
Programming a new timer event
> To programme a new timer event, use the
up/down
arrow keys to mark a free line in the menu Timer
overview.
> Press the
yellow function key New to open a win-
dow for the programming of the new timer event. Now
enter the data as described in
Point 7.15.1.2.
> Use the up/down arrow keys to mark the additional
field
Type.
> Confirm by pressing
OK. A window will be displayed,
showing the available timer types.
> Use the up/down arrow keys to select the desired
timer type.
> To accept the timer type into memory, confirm by pres-
sing
OK.
> When you have completed the programming, press
the
yellow function key Accept to accept the data
into memory.
Note!!!
Please ensure that the receiver has stored the current time in
memory. This will by shown on the display when the unit is in
standby mode. If this is not the case, switch your receiver on,
and leave it tuned to a major channel such as ZDF that car-
ries a time signal for approx. 30 seconds, so that the current
time can be stored in memory.
If you have activated this function in terms of Point 6.2.4, the
receiver should now show the current time on the display
while in standby mode.
Timeshift function
The timeshift function provides the opportunity of simultane-
ous recording and playback. This means that you can now
enjoy
timeshift television. Thus, you can view the begin-
ning of a recording, and decide to skip certain parts, such as
advertising. At the same time the recording of the live signal
continues (see examples below)
38
Bed_anl_.qxd 20.02.04 16:29 Seite 38