TechniSat S1 - Manual (Page 62)

While the positioning procedure is in progress, the
blinking message “
turn” will be displayed in the
menu.
9.4.1 Selecting a satellite position
In order to turn the dish antenna to the position specified in
the satellite list, your digital receiveris equipped with the
function
turn to Sat.
> Press the
yellow function key Actions to open the
window displaying the actions available.
> Use the
up/down arrow keys to mark the line turn
to Sat.
> Confirm by pressing
OK.
> Press the
green key (turn to Sat), the antenna will be
turned toward the satellite position selected.
9.5 Delete satellite position
To delete a satelite position from the satelite list, proceed as
follows:
>
Use the
arrow keys to mark the field Current
satellite list.
> Press
OK to display the current satellite list.
> Use the
up/down arrow keys to select the satellite
you wish to delete.
> Confirm by pressing
OK.
> Use the
arrow keys to mark the field Sat delete.
> To delete the selected satellite, press
OK, then
confirm the screen prompt by pressing
OK again.
9.6 Reference position
When installing the extern al installation, the rotary motor
must be in the reference position (
0°). This allows you to
move the motor position back to this reference position (
0°) at
any time by means of the command “
Go to reference
position”..
>
Press the
red function key Ref.pos to rotate the
antenna automatically to the reference position.
10 Technical Terms
Antenna cable:
Connecting cable between the modulator of the satellite recei-
ver and the antenna input of the television set. Used as an
alternative where no SCART socket is availabe
External installation:
Term used to describe the whole system mounted externally,
consisting of the parabolic or offset dish as well as one or
more LNCs, to provide reception from one or more satellites
AV: see SCART
62
(Fig. 9-4)
(Fig. 9-1)
(Fig. 9-2)
(Fig. 9-3)
Bed_anl_.qxd 20.02.04 16:29 Seite 62