Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 30)

- 14 -
Chapter 3 Operation
In this chapter, a description is provided of the operation methods that should be known for the
daily use of the Autoloader as well as information about the LCD indications.
3.1 Removal of the Magazine
Follow the procedure described below to remove the magazine from the Autoloader.
1. Check that the power of the Autoloader is ON.
Tip
The Autoloader has a double locking mechanism comprising a door lock and
an electronic lock. When the power is in the OFF condition, the electronic lock
is activated by a solenoid and the door cannot be opened. When it is necessary
to open the door while the power is in the OFF condition, use the emergency
release key that has been supplied. See “3.8 Using the Emergency Release
Key” for information describing the use of the emergency release key.
2. Use the door lock key supplied with the main unit to release the door lock, then open the front
door.
Tip
The Autoloader is designed so that the electronic lock operation will again be
activated if the front door is not opened within 10 seconds following the
release of the door lock with the door lock key. Should the door become locked
again, follow this same procedure to release the door lock and then open the
front door within 10 seconds.
3. Refer to the diagram affixed to the inside of the front door and press down on the lock lever
located at the lower left to release the magazine lock (see figure 3-1).
4. Pull out the magazine that has protruded (see figure 3-2).
Figure 3-1 Lock Lever Figure 3-2 Pulling out the Magazine