Tandberg Data Autoloader Tandberg LTO2 - Manual (Page 50)

- 34 -
4.3 Bar Code Label
The bar code label contains;
A volume serial number that you can read.
A bar code label that the Tandberg LTO2 Autoloader can read.
When appling a bar code labels to a cartridge position the bar code label only
in the recessed label area (see below figure). A bar code label that extends outside of this
recessed area can cause reading problems in the internal LTO drive or the robotics of the TD LTO2 Autoloader.
Sample Bar Code Label on the cartridge
Figure 4-3 Sample Bar Code Label on the Cartridge
Tip
Do not place any type of mark on the white space area at either end of the bar
code. A mark in this area may prevent the Tandberg LTO2 Autoloader from
reading the bar code label.
Using Bar Code Labels Precautions
When using a bar code labels, please observe the following precautions.
Use only TANDBERG DATA-supplied bar code labels.
Do not re-use a bar code label or re-apply a used bar code label over an existing label.
Before you apply a new bar code label, remove the old label by gently pulling it.
Remove the bar code label from the label sheet carefully. Do not stretch the bar code
label or cause the edges to curl.
Position the bar code label within the recessed label area..
Do not place other autoloader readable bar code labels on other surfaces of the
cartridge. They may interfere with the ability of the bar code reader to read the bar
code.